Water and electricity are a dangerous mix, and in Florida water can reach electrical equipment many ways: storm surge or flooding, a roof leak during a hurricane, or a burst pipe or water heater. What you do in the first hours matters for your safety and for what can be saved.
First, stay safe
- Do not walk into a flooded room or touch anything electrical while standing in water if the power may still be on.
- If you can reach the panel while standing on a dry surface with dry hands, turn off the main breaker. If you cannot reach it safely, stay out and call your utility to disconnect power.
- Stay far away from downed power lines and anything touching them, including water.
- If a generator is running, keep it outdoors and never connect it to the home without a transfer switch.

Why water-damaged parts usually need replacing
Breakers, outlets, switches, GFCIs and wiring that have been underwater can corrode and fail later, even if they dry out and seem to work. Floodwater carries salt, silt and contaminants that make this worse. The electrical industry’s guidance is that most water-damaged electrical equipment should be replaced rather than dried and reused. That includes panels and breakers that were submerged.
Before the power goes back on
- Have a licensed electrician inspect every circuit and device the water reached before power is restored to those areas.
- Expect outlets, switches and breakers that were underwater to be replaced, and wiring checked for damage.
- Have appliances, HVAC equipment and water heaters that were flooded checked before use.
- Take photos of the damage and keep invoices for your insurance claim.
For smaller leaks
A leak that drips into one outlet, light fixture or ceiling box still deserves attention. Turn off that circuit at the panel, leave fixtures off and have it checked. Water inside a box can cause tripping, heat and corrosion over time. If a GFCI keeps tripping after a leak, see why a GFCI keeps tripping.
When to call Advent Electric
Call whenever water has reached your panel, outlets, wiring or electrical equipment, before turning the power back on to those areas. Advent Electric can inspect, replace what was damaged and help you get power back safely, with paperwork for your insurance claim.
Related services and guides
Get your power back safely.
Advent Electric can inspect water-damaged electrical equipment and replace what needs replacing.
Request a quoteFrequently asked questions
Can I use outlets again after they dry out?
It is not recommended. Outlets, switches and breakers that were underwater can corrode inside and fail later. Most water-damaged electrical parts should be replaced, and the circuit checked, before it is used again.
Should I turn off the main breaker if my house is flooding?
Only if you can reach the panel while standing on a dry surface with dry hands. Never stand in water to reach a panel. If you cannot reach it safely, stay out and call your utility.
Does a water-damaged panel need to be replaced?
A panel or breakers that were submerged usually need to be replaced. An electrician can inspect it and explain what is needed before power is restored.
Will insurance cover water-damaged electrical work?
It depends on your policy and the cause of the water. Take photos, keep invoices and ask your agent. Advent Electric can provide documentation of the inspection and repairs.




